Float Check
Show Warp and Weft Float - Front and Back
Last updated
Was this helpful?
Show Warp and Weft Float - Front and Back
Last updated
Was this helpful?
This icon is available on the Project Tab.
Select whether to show floats only in the warp direction, weft direction or both.
Set the float values to any length. The default is 4.
Floats can be shown on the front, back or both using the "Cloth side" setting.
When "Show Floats" is clicked, a listing of each float matching the selected criteria is shown. In addition, the floats identified are surrounded by a red line in the drawdown when the identified float location is clicked.
By clicking on any of the identified positions, the drawdown will be repositioned to show the selected float.
