Create Double Cloth

Weave a flat design as two layers with a fold

* for now, be sure you save your design before clicking create double cloth. tempoweave will crash if the file has not been saved. This will be corrected on the next release *

Any flat woven cloth can be translated into a double cloth with a fold on either the left or right by using this utility on the design menu:

Create Double Cloth Icon

First design your cloth as if it were going to be woven without the fold (e.g. woven flat) at full width. Be sure to save your draft before clicking create double cloth as this action will transform your draft. It's good practice to save the full width draft with a name different than the double cloth version so that changes, if needed, can be easily made and the double draft regenerated.

For example, the simple twill pattern below, requiring 4 shafts and 4 treadles has a total of 800 warp ends, sett at 20 epi and requires 40 inches in the reed. Woven double, the draft will require 20 inches in the reed and 8 shafts and treadles.

Design for Blanket before folding double
Closeup of Design
Options for Create Double CLoth

After clicking the Create Double Cloth icon on the design tab, the above options are shown. Choosing fold on left and clicking ok transforms the draft into the following that will weave with a fold on the left and sett at 40 epi, requires double the shafts and treadles.

Closeup of Generated Draft Folded Double
Generated Draft Folded Double

The generated draft weaves the bottom layer with shafts 5-8 and assumes a treadling sequence of TBBT.

The project information cloth construction settings now move from Normal cloth to the following:

Cloth Construction Details - After Creating Double Cloth

View your new blanket using Cloth Sim on the View Menu:

Double woven cloth viewed with Cloth Sim

‚Äč